EDIT: The ESP for some reason now will not boot on the external power without pressing the reset button on it. It was not doing this before, but that is another problem for another day. It now works on the power supply and that's good enough for now.
I have a 12v power supply going into a 12-5v buck converter to power the project. The esps 5v pin is on the same rail as the buck converter's output, where the multimeter is plugged in. Both are at just under 5v, the USB is actually about 0.2v lower than the buck converter. The light on the esp will come on so it is receiving power, but the project does nothing.
I did change the motors from servos to steppers so I added multiple drivers and logic shifters and everything worked perfectly fine before that, but disconnecting them did nothing. The motors are not currently connected
The schematics are here . I've checked for connection problems but if it was connected wrong I'd imagine the esp would power on at all.…