Menu

Driving a Sony car radio LCD display with Arduino
📰

Driving a Sony car radio LCD display with Arduino

Adafruit Industries – Makers, hackers, artists, designers and engineers!·Anne Barela·5 days ago
#Gj5O8RVq
#adafruit#panel#arduino#serial#sony
Reading 0:00
15s threshold

Jose Luis Monteiro has reverse engineered the LCD on the detachable front panel of a Sony CDX-A250 car radio and driven it with an Arduino, with the project written up on Open Electronics.

The panel uses a SANYO LC75826W LCD driver, listed as IC901 in Sony’s service manual, and its serial lines come out on connector CN901. Three wires go to the Arduino for data, clock and chip enable, and the panel gets its +B supply from a bench power supply with ground shared with the Arduino.

The driver uses SANYO’s CCB serial format. Transfers start with device address 41H, then one of four 72-bit groups covering segments D1 through D208. The first group also carries the control bits for bias, segment count, frame frequency, oscillator mode and display on/off.

The datasheet doesn’t document which visible symbol maps to which bit position, so that part was worked out by testing.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.