Hi I built powerbank out of 18650's in 4s4p configuration, of course with bms and the charging board is IP2368 100W (bi-directional, single usb-c).
I wanted this powerbank to have cool display for information like voltage, current etc, but I hit the wall - it appears the only good, cheap and relatively high accuracy modules i can buy are from INA family, but most of the time shunt resistors on those boards are rated for 1A max. I know I can desolder this shunt and solder other one to handle for example 10A but I read that those boards and traces on the pcbs are not likely to handle this power over long periods of time.
Right now I have standard ssd1306 display with esp32c that reads voltage from ADC by using voltage divider with capacitor to filter out garbage:
R1: 100.4 KΩ R2: 15 KΩ C1: 100 nF (in parallel to R2)
I applied some corrections to the program reading by comparing it out to the multimiter.…