Menu

Pulling on a thread (Using Thread on Ikea Sensors)
📰

Pulling on a thread (Using Thread on Ikea Sensors)

Adafruit Industries – Makers, hackers, artists, designers and engineers!·Anne Barela·16 days ago
#LorE1ixf
#adafruit#thread#hardill#sensors#node
Reading 0:00
15s threshold

Ben Hardill wanted to read a pair of IKEA ALPSTUGA CO2 sensors from Node-RED, and wrote up what it took on his blog. The sensors are part of IKEA’s second generation of smart devices, so they use Thread radios instead of Zigbee. That rules out the old Trådfri Hub and Zigbee2MQTT. Thread runs an IPv6 network over low power radios, and it takes a Thread Border Router to connect it to WiFi or Ethernet.

His existing hubs were too old, so he picked up a Smlight SLZB-06MU, which can be flashed with OpenThread Border Router firmware or Zigbee2MQTT from its web interface.

Sam Machin wrote a Matter Controller node for Node-RED, but it only handled devices already on the LAN. It’s built on Matter.js, which supports Bluetooth commissioning, so Hardill added that and opened a pull request. The Thread network name and TLVs are set by hand for now, copied from the border router’s web page.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.