Menu

ESP32 WiFi Jam Detector finds the jamming
📰

ESP32 WiFi Jam Detector finds the jamming

Adafruit Industries – Makers, hackers, artists, designers and engineers!·Anne Barela·about 22 hours ago
#NZ1CU4Ms
Reading 0:00
15s threshold

TheDigital1 has published a receive-only RF interference detector for the Waveshare ESP32-C5-Touch-LCD-3.5. It uses the ESP32-C5’s own WiFi receiver as a snapshot SDR (software defined radio, where the radio hardware is tuned and read by code) through ESPARGOS esp-sdr, and draws the noise floor and spectrum for both 2.4 GHz and 5 GHz on the built-in touchscreen.

It doesn’t transmit. It can show that the RF environment changed, but it can’t prove intent: a running microwave oven looks like interference on 2.4 GHz, and the demo shows the status screen going to SUSPECT when one is nearby.

Captures run at 80 MS/s, and the central 48 MHz of a 1024-point FFT is kept and stitched into the band spectrum. Gain is fixed per band while sweeping, since hardware AGC would hide a raised noise floor. Detection compares the sweep against a learned baseline rather than an absolute level, because the receiver is uncalibrated.

A merged firmware binary is in Releases and is written over the board’s USB-C port.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.