Menu

Complete beginner here! Worried about shorting my ESP32 when connecting 5V sensors (pH, TDS, Turbidity)
📰

Complete beginner here! Worried about shorting my ESP32 when connecting 5V sensors (pH, TDS, Turbidity)

#esp32#redditesp32#beginner#turbidity#signal
Reading 0:00
15s threshold

Hi everyone! I’m a complete beginner working on a water quality monitoring project using an ESP32 DevKit.

I'm trying to connect my analog sensors (pH, TDS, and Turbidity modules), which output a 5V analog signal, to the ESP32's ADC pins (like GPIO 32, 34, or 35). Knowing that a direct 5V signal would fry the board, I spent around 5 hours researching online and found that I need a voltage divider using two 10kΩ resistors to step down the signal to around 2.5V.

(Note: Please ignore the Arduino Uno and the ultrasonic sensor in the Tinkercad diagram Tinkercad doesn't have an ESP32 or a turbidity/pH sensor, so I just used them as placeholders to show my resistor and breadboard wiring!)

However, since I'm very new to electronics, I'm quite nervous about short-circuiting my ESP32 or wiring things wrong.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.