Menu

Custom E-ink driver board (UC8252c). Charge pump not starting: PWM is active, but MOSFET Drain is stuck at 3.3V.
📰

Custom E-ink driver board (UC8252c). Charge pump not starting: PWM is active, but MOSFET Drain is stuck at 3.3V.

Reddit r/embedded·u/Sasu-X·7 months ago
#So4hvGPc
#uc8252c#pump#mosfet#high#charge
Reading 0:00
15s threshold

Hi everyone, I'm designing a custom driver board for a 2.13" E-ink display (controller UC8252c) driven by an RP2040 Zero via SPI. The digital logic seems to work perfectly, but the high-voltage DC-DC booster (charge pump) refuses to start.

Here is the situation:

Software/SPI: Working. I send the init sequence, the image data, and the refresh command (0x17 + 0xA5). The display acknowledges the command by pulling the BUSY pin LOW and holds it there (waiting for voltages to rise).

The Issue: The screen stays white because the high voltages are not being generated.

$V_{GH}$ reads 3.3V (should be +22V).

$V_{GL}$ reads ~0.1V and drops slowly (should be -20V).

Measurements on the Booster Circuit:

GDR (MOSFET Gate): 0.89V DC average. This means the UC8252c is correctly generating the high-frequency PWM signal to pump the inductor.

Drain (MOSFET Pin 3): 3.3V solid.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.