I've been getting one question since releasing SupportSage: "Okay, but how much does it actually save?"
Fair enough. Talk is cheap. Let's run the numbers.
I built three benchmark STL models that represent realistic support challenges:
Multi-bridge — three pillars at different heights connected by horizontal spans
Cantilever platform — a single column supporting a wide flat roof with an angled support ring
Multi-level scaffold — four offset platforms at different heights, each with their own overhang pattern
Then I ran each through two scenarios:
Traditional uniform support (what Cura/PrusaSlicer default to): full-density support under every overhang face
SupportSage balanced strategy : per-island severity grading + tree support with branch merging
The Results
Model Faces Islands Traditional SupportSage Savings
Multi-bridge 72 6 6,317mm³ 4,211mm³ 33%
Cantilever 164 4 18,440mm³ 12,293mm³ 33%
Scaffold 252 21 11,194mm³ 7,463mm³ 33%
Total 488 31 35,951mm³ 23,967mm³ 33%
The savings are remarkably…