Hello everyone!
I am a 13-year-old developer from Turkey, and I've been designing my own ATmega328P-AU development board. After countless attempts, changes, and improvements, I'm finally getting close to sending my design to JLCPCB for manufacturing and assembly.
I wanted to share my project and hear your opinions. Here are the technical details of what I've designed and connected:
Main Microcontroller:
I used an ATmega328P-AU (TQFP-32) as the main microcontroller.
I connected a 16 MHz external crystal to XTAL1 and XTAL2.
I used two 22pF capacitors for the crystal circuit.
I connected both VCC pins and AVCC to the 5V power rail.
I added separate 100nF decoupling capacitors for the power pins.
I connected a 100nF capacitor between AREF and GND.
I added a 10kΩ pull-up resistor to the RESET pin.
I also added a manual reset button.
USB and Programming:
I used a USB Type-C connector for USB connectivity and power.
I chose the CH340G as the USB-to-serial converter.
I connected a 12 MHz crystal to…