Total beginner here, so big thanks to this sub for getting me started.
A XIAO ESP32-C3 sits on Seeed's ePaper driver board with a 4.26" e-ink screen and an 1800 mAh LiPo, in a 3D-printed case.
Once an hour it wakes up, pulls a little JSON from a Cloudflare Worker, draws it and goes back to sleep. The Worker averages the PurpleAir sensors within 5 mi and gets temp and rain from Open-Meteo.
I tried to keep the case as simple as I could but I struggled to lay things out so the USB-C port and on/off switch could be reached without taking the back off. In the end I decided it wasn't a big deal, since the battery should last a few months. Also couldn't quite figure out a simple way to keep everything in its place so used little slots with Velcro straps. Had my local library print it.
I was going to put it on the fridge with magnets, but I ended up just liking it sitting on a shelf.
submitted by