
JLCPCB has a short video on tombstoning, the defect where a small chip resistor or capacitor stands up on one end during reflow soldering instead of lying flat on its two pads.
The cause is uneven wetting and heating. If one end of the part melts and wets its solder before the other, the surface tension pulling on that side wins, and the part is lifted off the opposite pad. The video is part of a series called SMT Defects Explained, and it covers chip resistors and capacitors in about four minutes.
Three layout checks reduce the risk. Pad symmetry means matching pad shape and size to the land pattern the part maker recommends. Trace symmetry means balancing trace widths, lengths and the copper areas connected to the two ends. Copper connections should be consistent, with spoke-style thermal reliefs where a direct connection to a large copper pour would otherwise heat one end slower than the other.
See the video below.