I'm making some quick copper tiles for a craft show next weekend. 6", 8" and 12". I'm including small walnut stands for the little ones but I also want to solder a small tab on the back for hanging. I don't want it to look stupid if using the stand, and I want it to make it so it can be leveled when hung. A loop or tab with round hole relies on me to get it perfectly level. I thought about the sawtooth shaped ones on some picture frames, but that would be tough to work harden after soldering. They look a bit cheesy already but I need some lower end easy sell stuff to make sure I don't lose money, it's my first show in 20 years. This is all air chisel "Repousse". Any suggestions for a simple hanger? submitted by /u/forgedcu [link] [comments]