Menu

Hover rest w/xceed2 riser

#archery#redditarchery#rest#riser#wire
Reading 0:00
15s threshold

Hi, i have somewhat of a question here regarding the use of a bicaster hover (similar to aae or spigarelli) arrow rest on my xceed 2 riser

I am under the understanding that upon release the vanes should push the rest wire fully flat agains the face of the riser

However since the throath on the xceed 2 is a bit thicker than standard, and this model of rest is installed on the opposite side, the wire cant be fully flattened

I know the obvious answer to this is using a stick on rest like the shibuya, but ive been told that unless i already have a very polished release technique (which i dont) i ll just break those more delicate rests

So my question really is how stupid of an idea would it be to phisically modify (bend) the wire so it can be fully flattened against the riser allowing the arrow to clear

Keep in mind that the “not clearing” is a couple mm at most, and my arrows fly fine as is, i just want it more perfect

Thanks

submitted by /u/Straight-Garage1244
[link] [comments]