Menu

Feedback requested: second prototype of my 3D-printed, battery-powered espresso machine

#maker#redditmaker#printed#pump#heater
Reading 0:00
15s threshold

Hi all. I’m a product designer from Italy. My first portable espresso machine was my university thesis: Open Sorso, 3D-printed with a manual syringe pump. It’s shared under CC BY-NC-SA. This is the second prototype, Briù. It’s still a rough prototype, and I’d love feedback from people who build things.

The build

Shell: 3D-printed in PETG

Power: 3S 18650 pack with a BMS

Brain: an ESP32-S3, with an MP1584 buck converter giving 5 V to the logic and the LEDs

Heater and pump: switched by MOSFET modules. The heater is ON/OFF, the 12 V pump runs on PWM, and an NTC reads the temperature.

Interface: one button and 3 WS2812B LEDs. Double click to heat, long press to brew.

Coffee: ESE pods. It heats 35–40 ml to 85–90 °C in about 7 minutes (I measured with a thermometer and a stopwatch).

A friend handled the electronics. I did the design and the printed parts.

What I learned the hard way

PETG vs heat. I took it out on a boat. In direct sun, the shell near the heater partly deformed inward.

Tank fitting.…

Continue reading — create a free account

Join HashtagPLUS to read full articles, follow hashtags, vote, and join the conversation.