Eric Weinhoffer built a desk lamp around flexible filament LEDs, the bendable strands that have largely replaced EL wire for this kind of thing. They are brighter, more flexible, and easier to drive, though still fragile enough that a few broke during repeated assembly and disassembly.
The circuit runs a 3.7 V LiPo into a PowerBoost , which steps it to 5 V and handles USB charging. A 3.3 V regulator brings it back down for the LEDs , with resistors limiting current per strand. The backlit button switches the PowerBoost enable pin rather than the battery, so the lamp can charge while off.
Holding the filaments was the harder problem. All the parts were printed on Form 4 SLA machines, so the design borrows from machining: a collet plate and a matching nut plate at each end, with tapered surfaces that close three collets around the strands as a single M4 bolt is tightened.…