Menu

Reading 0:00
15s threshold
Copper knife

Working on this copper knife, I had three sheets of copper to thicken the blade a bit. Currently using lead free solder to try and merge the copper plates into one. Cherry wood handle, might not be the prettiest blade but it is strong for being primarily pure copper.

I tried using some sil-fos but it ended up heating the copper so much that it began to char the wood.

I used hollow steel rivets to fasten the handle to the copper, and some JB weld to fill in the gap.

Open to any suggestions!

submitted by /u/Substantial_Ice_9329
[link] [comments]