Menu

How would you set this up?
📰
Reading 0:00
15s threshold
How would you set this up?

I have a model for one of the Dune popcorn buckets. I was hoping to print in tpu, however no matter what type of filament I use, I feel like the supports for the spikes will be a nightmare regardless. The spikes only go for about an inch so they don't run all the way through this model.

My current solution is I'll setup supports and just hope the top looks good enough that whatever mess is left underneath won't matter so much. Unfortunately it does not have a version where I can print without the teeth but I'm capable enough that I can edit the model and remove them and then just add them one by one later I suppose.

I'm not against splitting the model if anyone has an idea I haven't thought about I'm open to it.

Edit: Thank you all, I've never had a post have so many legit helpful and then unhelpful but still necessary comments

submitted by /u/SuperNntendoChalmerz
[link] [comments]