#RedditWelding

This is 316 stainless, 1/4" thick. I'll be welding the ribs to the inside of the ring where the radius is. I went to a local welding supply shop and they said they've never welded before and couldn't say.... I have a dual feeder, if that's necessary.…

Hey folks. Im in process of fixing this trailer up. there are a few spots I need to weld, and I was thinking about just doing a solid reinforcement all around.…

Im having to do some body work repair. All I have is a fluxcore welder and it burns through sheet metal super easy even on low settings so I'm just doing small tack welds.…

Im not a welder. I do some fabrication on cars, have made chassis for hotrods, rebuilt and done restos on classics, making bits and pieces, I can MIG weld and thats what I am most experienced with, done a little MMA in the past too and my TIG is decent…

I'm welding some 1x2 rectangular steel tube, 14 gauge. I'm using .030 with C25 at 25cfm, 18.3 volts and 230 ipm. Gun angle is directly above the weld, pushing at maybe 15 degrees. Prepped with a flap disk and acetone.…

How do you achive such even seam. I found it on a chair in a lobby of buiding supply seler and i am wondering how it is posible to make such straith and even seam. There was no visible gap or edge. submitted by /u/crypro-for-all [link] [comments]

Hey guys been looking at these helmets and for those of you that have this helmet how is it? I work in a fab shop lots of dust, rust and cleaning we have to do on beams we work on.…

I'm interested in welding as a career and I know Stick and Flux Core welding. What are some fields and careers I can get into? submitted by /u/Available-Barnacle11 [link] [comments]

I'm about to finish my welding school. What mask should i get. I truly don't know, can you give some option of good and not expensive mask that i can get in Canada submitted by /u/Straight_Pizza_8980 [link] [comments]

Have an opportunity to get a free working welder. I don’t need it as I have my own mig and access to welders at work but thought maybe I could make some money off it. Scrap yard said $40 complete as it weighs over 800lbs.…

With the success of that stick welder from temu being way more than I had expected I do find myself in need of a spot welder for standard duct work sheet metal. Has anyone seen any advertised cheap on temu that would work?…

I'm not sure what the proper English term for it is since I'm translating from my own language here, but how do you guys deal with tacks that magnetized the surrounding area?…

I already have a very good career going. Just looking to learn a trade. Maybe one day make it a side job.

Pearl snaps, wranglers, boots, sometimes I’ll even see welders rocking cowboy hats and giant belt buckles. Nothing wrong with that. I’m just curious. submitted by /u/MauserMama [link] [comments]

So I'm looking to weld on some light bar brackets, maybe eventually build a bumper for my offroad rig, and learn how to weld a nut onto the rusty pig if I need to.…