#Weld

So I'm looking to weld on some light bar brackets, maybe eventually build a bumper for my offroad rig, and learn how to weld a nut onto the rusty pig if I need to.…

Im not a welder. I do some fabrication on cars, have made chassis for hotrods, rebuilt and done restos on classics, making bits and pieces, I can MIG weld and thats what I am most experienced with, done a little MMA in the past too and my TIG is decent…

I'm welding some 1x2 rectangular steel tube, 14 gauge. I'm using .030 with C25 at 25cfm, 18.3 volts and 230 ipm. Gun angle is directly above the weld, pushing at maybe 15 degrees. Prepped with a flap disk and acetone.…

One of the guys in our shop did this weld The symbol on the drawing is 5 | | What do you guys think of this weld and how can we improve it ? The gap between the plates is 3mm narrowing to 1.5mm 6mm HRPO weld submitted by /u/lightbluelightr [link]…

Hello how long should it take to weld 6" sch40 carbon tig in a 5g? Im trying to get faster and i want a target to aim for. submitted by /u/Oofman1001 [link] [comments]

I tried to weld a piece that broke off the electric motor of my lathe back on. The first part of the weld went really well and the old cast aluminium was way better than I expected.…

Kawasaki unveiled a 60x44x29 cm four-legged robot that grips hulls with electromagnets for welding and seam checks. Demo 2027; practical use targeted...

Kawasaki unveiled a 60x44x29 cm four-legged robot that grips hulls with electromagnets for welding and seam checks. Demo 2027; practical use targeted...

Hi this is for a failure analysis project, and just wanted to hear other opinions on whether this would be considered a “good” or “bad” weld

Took my first weld test and got the results back today. And I passed! It was just a 1G but I’m pretty happy with it all things considered. Only been doing this for about six months maybe. And suggested improvements?…

I am trying to make a 3/4" thick angle iron , im told to groove one plate and put a fillet along the inside Is this weld symbol correct?

tried to weld a broken pipe handle with a stick welder. it is imprtant to note that it was my first time and i tough i could just blob weld them together. i thing i needed to up the amprege more.…

Ignore the 2 welds above, that wasn't me, the way bigger one is mine. And this was just practice, was cut off by the bell, so I only got this weld. Mig weld by the way, 20 volts. The white stuff is chalk.…